How to select the correct water inlet mode for electric faucet

Recently, many friends reported that the newly purchased instant electric faucet could not be installed. Why?

In fact, this is not the problem of the water tap itself. The key is that the water inlet mode is not well selected.

Instant electric water faucets, also known as hot water treasure, hot water, etc., are cold water that passes through the internal heating pipe, and hot water will come out in 3 seconds. This small water heater is designed to provide hot water for kitchen sink or washbasin in the bathroom and other places to meet the daily use of washing dishes, dishes, pots and washes on the washstand in the bathroom.

In this way, the water heater is characterized by convenient installation. As long as the water is connected and powered on, there are two gears: cold and hot water. When the handle is turned to the left, hot water is produced. When the handle is turned to the right, hot water is produced. When the handle is not in the middle, no water is produced. As much hot water as electricity is used, the power is generally about 3KW, with high thermal efficiency and power saving, so it is loved by users.

Many friends found that the newly acquired electric faucet could not be installed, mainly because they did not choose the correct water inlet method. The electric faucet only needs to be connected with cold water for water inlet. There are two water inlet modes: water inlet and side water inlet.

Lower water inlet: that is, electric faucet, which is penetrated from the table top hole, and connected with two flat braided hoses with a base of 4 points below. Many friends' homes used to use cold and hot water faucets in their homes. The hoses connected were sharp at one end and flat at the other. Two of the four points must be replaced and connected by flat braided hoses! For the electric faucet with water inlet, the electric wire of the machine can be connected on the platform, or it can be connected from below through the machine threading hole, and the electricity can be switched freely under the platform or under the platform, which is very convenient.

Side water inlet: generally, it is an old-fashioned house or waterway. The water outlet is on the wall of the panel, and it is directly connected with the water outlet from the back of the electric faucet. The electric faucet with such water inlet mode can only be connected on the platform.

Therefore, when choosing electric faucets, friends should choose the right water inlet mode according to the installation environment at home. If the choice is wrong, there is no way to use it. Please pay attention to the installation and use of electric faucets.